Differences

This shows you the differences between two versions of the page.

--- en:dev:eargear-v2-protocol [2026/08/11 17:56] – [EarGear v2 Protocol] darkgrue
+++ en:dev:eargear-v2-protocol [2026/08/11 17:58] (current) – darkgrue
@@ Line 4: / Line 4: @@
 <WRAP round important 90%>
-This protocol only applies to the EarGear 2 product's original shipping firmware, which is deprecated. Current EarGear 2 products use the TailControl firmware. Refer to the [[en:dev:tailcontrol-command-protocol|TailControl Command Protocol]] documentation.
+This protocol only applies to the EarGear 2 product's original shipping firmware, which is **deprecated**. Current EarGear 2 products use the TailControl firmware. Refer to the [[en:dev:tailcontrol-command-protocol|TailControl Command Protocol]] documentation.
 </WRAP>
 ===== Differences between v1 and v2 =====
@@ Line 15: / Line 17: @@
 A press of 2-3 seconds starts up and shuts down EarGear. Connecting a charger to the EarGear inhibits the ''ENABLE'' line of the 3.3 V regulator, which means the EarGear cannot be turned on while charging.
 ===== Device Advertisement =====
@@ Line 27: / Line 30: @@
   * Battery Percentage (0-100%), and
   * Battery Voltage (in Volts).
 ==== nRF Connect for Mobile ====
 [[https://www.nordicsemi.com/Products/Development-tools/nrf-connect-for-mobile|nrf Connect for Mobile]] is a highly recommended tool for assisting with development and troubleshooting connectivity when developing your own controller or app software.
 ===== Ear Commands =====