Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:manuals:service-notes-for-mitail [2025/09/03 19:16] – [HomePosition] darkgrue | en:manuals:service-notes-for-mitail [2025/09/03 19:17] (current) – [MiTail Case] darkgrue | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| ===== MiTail Case ===== | ===== MiTail Case ===== | ||
| + | The MiTail case is injection-molded ABS. Replacements may be ordered from The Tail Company, or installed by a repair depot. | ||
| ==== Case Screws ==== | ==== Case Screws ==== | ||
| Line 17: | Line 18: | ||
| Replacing the lower case half (with the belt hook portion) is the most common reason for replacing the MiTail case. This requires that the case be opened, the two batteries taken out of the case, the control board removed, the four servo frame mount screws be removed, and the servo pulley be removed from the servo. The cable must be removed from the pulley to remove the case half from the cable. | Replacing the lower case half (with the belt hook portion) is the most common reason for replacing the MiTail case. This requires that the case be opened, the two batteries taken out of the case, the control board removed, the four servo frame mount screws be removed, and the servo pulley be removed from the servo. The cable must be removed from the pulley to remove the case half from the cable. | ||
| - | The disassembly is then reversed. Note the procedure in [[#HomePosition|Resetting Servo Home Position]] to reset the pulley position on the servo shaft correctly. | + | The disassembly is then reversed. Note the procedure in [[# |
| ===== Installing the Control Board ===== | ===== Installing the Control Board ===== | ||