Trace:

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
en:manuals:service-notes-for-mitail [2024/11/11 18:01] – darkgrueen:manuals:service-notes-for-mitail [2025/03/05 13:10] (current) – [Case Screws] mastertailer
Line 1: Line 1:
 ===== Introduction ===== ===== Introduction =====
  
-These instructions do not purport to cover all details or variations of the product and do not claim to provide for every possible contingency in connection with installation, operation, or maintenance. Self-repairs performed by the customer may lead to damage or loss of your product. Should further information be desired or should particular problems arise which are not covered sufficiently or if repair services are desired, please contact The Tail Company (contact@thetailcompany.com).+These instructions do not purport to cover all details or variations of the product and do not claim to provide for every possible contingency in connection with installation, operation, or maintenance. Self-repairs performed by the customer may lead to damage or loss of your product. Should further information be desired or should particular problems arise which are not covered sufficiently or if repair services are desired, please contact The Tail Company ([[contact@thetailcompany.com]]).
  
 For the purposes of this manual, “left” and “right” references will refer to the MiTail’s orientation when worn on the body, relative to the wearer. So, the “left” side is the side of the MiTail on the wearer’s left. For the purposes of this manual, “left” and “right” references will refer to the MiTail’s orientation when worn on the body, relative to the wearer. So, the “left” side is the side of the MiTail on the wearer’s left.
Line 9: Line 9:
 There are eight Phillips-head self-tapping screws holding the case together, in addition to a serial number foil that must be cut or removed to open the case. One of the screws is behind the left actuator cable, and is easy to miss. There are eight Phillips-head self-tapping screws holding the case together, in addition to a serial number foil that must be cut or removed to open the case. One of the screws is behind the left actuator cable, and is easy to miss.
  
 +
 +{{ :en:manuals:mitail_case_8_holes_.jpg?400 |}}
 ===== Installing the Control Board ===== ===== Installing the Control Board =====
  
Back to top