Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:manuals:service-notes-for-mitail [2024/07/21 16:38] – [Glow Tip - Installing LED Lights] darkgrue | en:manuals:service-notes-for-mitail [2024/07/22 12:57] (current) – [Installing Servos] darkgrue | ||
---|---|---|---|
Line 47: | Line 47: | ||
===== Installing Servos ===== | ===== Installing Servos ===== | ||
- | The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos. | + | The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos. |
{{ : | {{ : | ||
Line 77: | Line 77: | ||
The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair (closest to the edge of the board) of pins on J5 (positive pin is up, negative pin is closest to the PCB). | The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair (closest to the edge of the board) of pins on J5 (positive pin is up, negative pin is closest to the PCB). | ||
- | {{: | + | {{ : |
===== Charging ===== | ===== Charging ===== |