Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:manuals:service-notes-for-mitail [2024/03/21 10:26] – external edit 127.0.0.1 | en:manuals:service-notes-for-mitail [2024/07/22 12:57] (current) – [Installing Servos] darkgrue | ||
---|---|---|---|
Line 47: | Line 47: | ||
===== Installing Servos ===== | ===== Installing Servos ===== | ||
- | The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos. | + | The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos. |
{{ : | {{ : | ||
Line 73: | Line 73: | ||
{{ : | {{ : | ||
- | ===== Installing LED Lights ===== | + | ===== Glow Tip - Installing LED Lights ===== |
- | The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair of pins on J5 (positive pin is up, negative pin is closest to the PCB). | + | The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair (closest to the edge of the board) |
+ | |||
+ | {{ : | ||
===== Charging ===== | ===== Charging ===== |