Differences

This shows you the differences between two versions of the page.

--- en:manuals:service-notes-for-mitail [2023/12/12 08:25] – mastertailer
+++ en:manuals:service-notes-for-mitail [2024/07/22 12:57] (current) – [Installing Servos] darkgrue
@@ Line 47: / Line 47: @@
 ===== Installing Servos =====
-The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos.
+The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos. They are 4.5-6.4VDC standard hobby servos
 {{ :en:manuals:servo.jpg?nolink&600 |}}
@@ Line 73: / Line 73: @@
 {{ :en:manuals:pulley_alignment.jpg?nolink&600 |}}
-===== Installing LED Lights =====
+===== Glow Tip - Installing LED Lights =====
-The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair of pins on J5 (positive pin is up, negative pin is closest to the PCB).
+The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair (closest to the edge of the board) of pins on J5 (positive pin is up, negative pin is closest to the PCB).
+{{ :en:manuals:glow_tip.jpg?400 |}}
 ===== Charging =====
@@ Line 107: / Line 109: @@
 Test that the tail charges and indicates charging and end-of-charge correctly.
+== Copyright 2023 © The Mechanical Tail Company Limited contact@thetailcompany.com. All Rights Reserved. ==