Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
en:manuals:service-notes-for-mitail [2023/12/07 00:47] – created darkgrue | en:manuals:service-notes-for-mitail [2024/07/22 12:57] (current) – [Installing Servos] darkgrue | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Introduction ===== | ===== Introduction ===== | ||
- | These instructions do not purport to cover all details or variations of the product and do not claim to provide for every possible contingency in connection with installation, | + | These instructions do not purport to cover all details or variations of the product and do not claim to provide for every possible contingency in connection with installation, |
For the purposes of this manual, “left” and “right” references will refer to the MiTail’s orientation when worn on the body, relative to the wearer. So, the “left” side is the side of the MiTail on the wearer’s left. | For the purposes of this manual, “left” and “right” references will refer to the MiTail’s orientation when worn on the body, relative to the wearer. So, the “left” side is the side of the MiTail on the wearer’s left. | ||
Line 47: | Line 47: | ||
===== Installing Servos ===== | ===== Installing Servos ===== | ||
- | The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos. | + | The tails use two 5521MG-equivalent 180 Degrees 20KG digital (PWM, **not ** serial) servos. |
{{ : | {{ : | ||
Line 73: | Line 73: | ||
{{ : | {{ : | ||
- | ===== Installing LED Lights ===== | + | ===== Glow Tip - Installing LED Lights ===== |
- | The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair of pins on J5 (positive pin is up, negative pin is closest to the PCB). | + | The tails use 3 or 4 5V SMD 3528 LED strip lights, connected to the first pair (closest to the edge of the board) |
+ | |||
+ | {{ : | ||
===== Charging ===== | ===== Charging ===== | ||
Line 107: | Line 109: | ||
Test that the tail charges and indicates charging and end-of-charge correctly. | Test that the tail charges and indicates charging and end-of-charge correctly. | ||
+ | |||
+ | |||
+ | == Copyright 2023 © The Mechanical Tail Company Limited contact@thetailcompany.com. All Rights Reserved. == | ||
+ | |||