Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| en:dev:tailcontrol-command-protocol [2025/06/16 23:26] – [Developer Commands (use at own risk)] darkgrue | en:dev:tailcontrol-command-protocol [2025/06/21 14:27] (current) – [Conference Mode] darkgrue | ||
|---|---|---|---|
| Line 372: | Line 372: | ||
| * **Replay Attack:** a type of network attack in which an attacker captures a valid network transmission and then retransmits it later. The main objective is to trick the system into accepting the retransmission of the data as legitimate. | * **Replay Attack:** a type of network attack in which an attacker captures a valid network transmission and then retransmits it later. The main objective is to trick the system into accepting the retransmission of the data as legitimate. | ||
| + | <WRAP round important 90%> | ||
| + | Do NOT attempt to use Conference Mode on TailControl firmware prior to 5.3.0, or a condition requiring repair of the control board can occur.</ | ||
| ==== Enabling Conference Mode (Pairing and Binding) ==== | ==== Enabling Conference Mode (Pairing and Binding) ==== | ||